Electrical, Instrumentation, Controls (EI&C) & Fiber Optic

ELECTRICAL, INSTRUMENTATION, CONTROLS (EI&C)

Integrity Specialists International, Inc. (ISI) management has a combined 80 years of proven expertise providing Electrical, Instrumentation, Controls, and Fiber Optic solutions. Whether the project requirements are manpower solutions or completing the full process of design review, installation, energization, commissioning, and providing support through start-up and stable operations, ISI has the project covered with confidence.

The electrical, instrumentation, controls, solutions that ISI provides include, but are not limited to the following:

Substation Solutions

 

  • Development of Operating and Maintenance Procedures
  • Equipment Storage and Preservation Management
  • Installation
  • Transformer Inspection and Testing
  • Switchgear Inspection, Maintenance, and Repair
  • Protective Relay Inspection, Upgrades, and Testing
  • HV Disconnects and Circuit Switchers Inspection and Re-Alignment
  • Load Tap Changer Inspections and Maintenance
  • SF6 Breaker Service Inspection and Repair
  • Oil Circuit Breaker Inspection and Maintenance
  • Transformer Oil Purification
  • Unmanned Ariel Surveys (Drones)

Power, Controls & Communications Solutions

 

  • Development of Operating and Maintenance Procedures
  • Equipment Storage and Preservation Management
  • Grounding Installation, Testing, and Termination
  • Cable Tray Installation
  • Conduit Installation
  • Low Voltage Wiring Installation, Testing and Termination
  • Medium Voltage Cable Installation, Testing, and Termination
  • High Voltage Wiring Installation, Testing and Termination
  • Switchgear Installation and Inspections
  • Motor Control Center (MCC) Installation and Inspections
  • Transformers Installation and Inspections
  • Heat Tracing Installation and Testing
  • Uninterruptible Power Supply (UPS) Installation & Testing
  • Lighting and Lighting Protection Installation and Testing
  • Control Panel, DCS & PLC Installation and Testing
  • Fiber Optic Terminations
  • Lockout / Tagout Program Management
  • Labeling and Tagging
  • Commissioning and Energization

Instrument Installation & Technical Solutions

 

  • Equipment Storage and Preservation Management
  • Pre-Installation Checkout and Calibration
  • Installation
  • Tubing Flushing, Testing, and Installation
  • Calibration
  • Loop Check
  • Loop Testing
  • Analyzer Installation & Testing
  • Labeling and Tagging
  • Commissioning and Start-Up

FIBER OPTIC

The fiber optic solutions that ISI provides include, but are not limited to the following:

Engineering Support Solutions

 

  • Technical Advisory During Design and Installation
  • Design Installation Reviews and Recommendations
  • Construction Plan Reviews and Recommendations
  • Procurement and Factory Acceptance Testing Management
  • Equipment Preservation, Packaging, Transportation Management
  • As-Built of Drawings and Documentation Post Installation
  • Input and Recommendations to RFP / RFQ

Installation Preparation Solutions

 

  • Site Assessment for Installation
  • On-Reel Pre-installation Cable Testing
  • Trenching
  • Duct Bank and Underground Cabling Raceways Installation
  • Underground / Above Ground Conduit Installation
  • Cable Pulling
  • Panel Installation and termination

Installation, Termination, and Testing Solutions

 

  • Splice Closure Setup and Installation
  • Mechanical and Fusion Fiber Optic Cable Splicing
  • CATV Fiber Optic Node Splicing and Installation
  • Direct Termination of Fiber Cable
  • Patch Cords Installation and Testing
  • Termination Panel Labeling and Port Assignment Verification
  • Post Installation Cable Testing

Operation and Maintenance Solutions

 

  • ISP Network Inspection and Troubleshooting
  • OSP Network Inspection and Troubleshooting
  • Cable Restoration and Maintenance
  • Fault / Break Locating, Remediation, and Repair
  • Quality Control and Testing, Commissioning and Energization